Pulling in the screens

Aluminum screens should be installed with the shiny side up. On non-aluminum screens, the upper side is indicated with a text or sticker. “THIS SIDE DOWN” is printed on the profile sides of the screen. When the screen is correctly installed, you should be able to read the Svensson logo and the product family name while standing inside the greenhouse.

To pull in the screens with minimum friction, we recommend using a steel tube in a holder with bearings or a teflon holder. This will reduce stretching of the screen while pulling it in.

Note: Foil rolling devices are not recommended as they can damage the screen.

When pulling in the screen, make sure that the angle is greater than 110° and the screen is pulled over a smooth plastic tube Ø 125 mm or larger.

pulling-the-screen
Correct pulling in screen

Facilitate unrolling the screen by guiding it at both sides manually.

While pulling in, we recommend keeping the screen as wide as possible; this helps to maintain the structure of the screen. 

correct-pulling not-correct-pulling

Pulling in wide

While pulling in the screens, watch out for sharp objects like heating installations, crop-hooks, profiles etc.

Unless pieces are cut to length* when there is more than one sheet on a roll you’ll find two blue lines marking the border between the sheets.
In between these lines you will find tape with a white cutting line. The screen can be cut along the cutting line with a hot knife or power scissors.

* for the America's markets, pieces are always cut to length 

        cutting-screen       
Hot knife or power scissors

Sign up for our newsletter